This page may contain affiliate links. If you click and make a purchase through these links, I may earn a small commission at no additional cost to you. Click here to see my full disclosure policy.

Tuesday, May 24, 2011

Silhouette SD Beta Plug-in Available now!



MTC-Silhouette SD users! The days of using the printer driver to cut out your SVGs with Make-the-Cut are coming to an end, the Silhouette SD Beta Plug-in is now available! I have used it to cut out SVGs and for Print-and-Cut with the Silhouette. If you are up for it, just click on this link to get your beta plug-in. Bear in mind that this is just the beta version and there may be errors that will need to be fixed by Andy. If you decide to try the plug-in for print-and-cut, please watch this video first: 




To get your Silhouette SD Beta plug-in, just click on the following link:


Edit: Please note that there is an error in the wording in the video. If you are testing the beta plug-in, it is important that you not hide the registration marks. Andy can explain that better than I can:


3 comments :

  1. Jin, which do you think is easier to use for print and cut with MTC, the Lynx or Sil? Thank you.
    MaryT

    ReplyDelete
  2. Hi Mary, I have yet to try print-and-cut with the Lynx but I have found it very easy to do so with the Silhouette. :)

    ReplyDelete
  3. My Silhouette is on the way!!! Thank you for all of your reviews and your input!! :)
    MaryT

    ReplyDelete